The water tank temperature of the laser cutting machine is important, too high or too low, it is not suitable. The temperature of the water tank of the laser cutting machine is 20℃ to 35℃.

How to maintain the water tank temperature of laser cutting machine?

1.Summer temperature control: the hot water temperature of the chiller (laser fiber temperature) must be set at 29-30 degrees, the warm water temperature should not exceed 30 degrees, and pay attention to check whether the hot water temperature reaches 29-30 degrees during the working process; The cold water temperature (cooling laser temperature) is set at 22-25 degrees.

2.Winter antifreeze: laser cutting machine stop working, the external ambient temperature ≤4℃, the water tank must be added antifreeze, antifreeze according to the product instructions. Or drain the water inside the tank and laser every day to prevent the water from freezing and cracking the pipe and damaging the machine. Be sure to drain the water when draining, laser, evaporator, water tank, water pump can not have water, to prevent ice damage to the machine, can be less than 0.5MPA air pressure to blow the water clean. Start the machine again, the temperature is still very low, there are still a few ice particles in the water tank, be sure to add 25-30℃ warm water to the water tank, after the ice melts, then start the water tank cycle for production, not according to the above operation does not belong to the manufacturer's warranty.