First of all, before the operation of CNC press brake, we need to understand the equipment components of CNC press brake, its overall structure is mainly divided into three parts: bracket, clamping plate and workbench, each part is indispensable, in the process of use must ensure that the three are no problem to continue to operate. The use principle of CNC bending machine is mainly when the wire and the coil are powered on the pressure plate will generate gravity, when the gravity can achieve the clamping between the pressure plate and the base, so as to achieve the bending of the plate, the specific operation tutorial is as follows:

1, power preparation

To use the CNC press brake, the first thing to do is to make the press brake power first, we need to turn on the power switch on the control panel of the bending machine, and then start the oil pump, if we hear the sound of the oil pump rotating then it means that the press brake has no problem, at this time we do not need to do any work, let the oil pump idling about 80s;

2, stroke adjustment test

In the second link, we need to test the machine and adjust the stroke. The specific operation is mainly to retain the thickness of the sheet material when the upper die goes down to the bottom position. This step is an important link to ensure that the press brake can work normally without affecting the service cycle of the press brake, and must not be ignored.

3. Select the notch

The thickness of the bending, the size of the notch in this step to choose, according to the actual standard to set the program, in the industry standard range, the size of the notch according to the thickness of the plate to determine the normal selection of plate thickness 8 times the width of the socket size, such as bending 3mm plate, need to choose 24mm notch, the calculation is very simple;

4, adjust the back stop material

This step is mainly to confirm the position and specification of the rear material to ensure that it can work normally;

5, step on the switch can work

After the above preparation and test work is done, we can step on the switch to start the plate bending, it should be noted that the pedal of the bending machine can be loosened at any time, and the principle of loosening and stepping is to loosen and stop the stampede work, which is very simple.