CNC press brake is widely used in aircraft, automobile, shipbuilding, electrical appliances, machinery, light industry and other manufacturing industries.So correct operation and simple use is very important. When using the machine, there are several tips.

CNC press brake operation

- The operator should check all connection bolts and fittings frequently to ensure that they are tightened before operation.

- The main parts of the machine, such as the frame, are welded.

- When using CNC press brake, the operator should check the weld frequently during operation.

- If cracks are found, the machine should be shut down immediately and can only be repaired by technicians before operation.

CNC press brake back stop

- CNC sheet metal bending rear stop is driven by servo motor, which can achieve accurate positioning.

- We need to regularly check the gap between the lead screw and the nut, and re-tighten or replace worn parts when the gap is too large to ensure accurate positioning.

- The operator is forbidden to adjust the rear stop finger before the machine.

Die operation on press brake

- When using a press brake, we bend different materials, different plate thicknesses, widths and lengths

- So the top tool and the bottom mold must be selected correctly.

- When the plate thickness changes, the opening width of the lower die needs to be re-selected.

- When bending short workpieces, the operator should place the plate in the middle of the machine to avoid load imbalance.

- We often need to adjust and change the opening of the bottom die, at this time we can use the ring to turn or move the bottom die to select the correct CNC press brake to bend the V-groove on the die.

CNC press brake safety

- Do not put your hand or any part of your body into the mold area at any time.

- Do not adjust any part behind the plunger from the front of the machine through the die area.

- The body should be far away from the workpiece, so as to avoid damage caused by the bending of the workpiece when the machine is running.

- When the CNC press brake stops working, the ram must remain at bottom dead center.

Press brake power safety

- The operator can not weld on the machine, and can not connect high power.

- We cannot use them as ground conductors.

- Ensure that the high power point of the machine is stable and there is no high voltage circuit.

Operating environment

- CNC press brake should be installed in the workshop without direct sunlight.

CNC press brake in overload

- The machine should be operated within the rated pressure range, otherwise serious accidents may occur.

- When we buy a press brake, it is best to choose a machine with compensation.